A.O. Smith LOTUS-75M, Руководство пользователя

Страница: 15 / 48

ENG 13
• Drain Hole
A small hole is located at the bottom of the appliance. This hole is tapped
with a rubber cap. When there is water leakage inside the cabinet, this
hole is used to drain the water.
Follow below steps in case of a water leakage inside the cabinet:
• Cut inlet water line and power to the unit.
• Take the unit inside sink.
• Remove the rubber cap located just at the middle of unit base.
• Wait until the water inside the cabinet is evacuated.
• After all water is evacuated, place the rubber cap on the drain hole.
Installation Notes
• When installing the water pipes, you should not install a drain stopper.
Furthermore, the screw nut on the water pipe bottom connector should
have no wire teeth exposed.
• If the inlet water pipe is 9mm, you should ensure that the inlet water
pipe and connector have 30-40cm of straight piping to avoid pipe
bursting accidents caused by bending of the pipe.
• If the power cord wiring needs to be longer, extend the cord according
to the wiring requirements and use an 8mm pinched tube to wrap
around the connection. Later, wrap insulating electrical tape
on the outside surface. Do not place the cord on the floor. The cord
should be suspended in the air or should follow a path above ground.
• During installation, make sure that there is no electrical wiring or water
pipes embedded inside the walls where you will do the drilling.
Right way to cut pipes Wrong way to cut pipes
Diagram 10
Diagram 13
Diagram 11
Diagram 12
Clip (Before installation) Clip (After installation)
Drain Hole with rubber cap
at the bottom of the unit.
Remove the rubber cap when
there is a leakage.