A.O. Smith ITES 1000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 66 / 101

Installation-, user and service manual
64
3.2.4
Water compositions
Hardness
(alkaline earth ions)
> 1,00 mmol/l:

German hardness > 5.6 °dH

French hardness > 10.0 °fH

English hardness > 7.0 °e

CaCO
3
> 100mg/l
Conductivity > 125
μS/cm
Acidity (pH value) 7.0 < pH value < 9.5
Note
If the water specifications deviate from those stated in the table, then the tank protection
cannot be guaranteed (11 "Warranty").
Working clearances
For access to the water heater, it is recommended that the following clearances are
observed (see figure):

AA: at the front of the water heater: 120 cm.
 BB: around the water heater: 30 cm.

Top of the water heater: 30 cm
Working clearances
IMD-0919 R0.0
Note
When installing the water heater, be aware that any leakage from the tank and/or
connections can cause damage to the immediate environment or floors below the level
of the boiler room. If this is the case, the water heater should be installed above a waste
water drain or in a suitable metal leak tray. The leak tray must have an appropriate waste
water drain and must be at least 5 cm deep with a length and width at least 5 cm greater
than the diameter of the water heater.
3.3 Technical The water heater is supplied without accessories. Check the dimensions, general
specifications specifications and electrical specifications and of any accessories you plan to use.
A
A
B
B