4. Setting the clock
In ‘clock’ mode, hold down the ‘Program’ button for 3 seconds
till the time on the screen flashes. Press the “
” the “
”
buttons to set the hour, then press the ‘Program’ button again
to confirm the hour. Similarly, use the “
” and“
” buttons to
set the minute. Holding down the adjustment buttons will cause
the digits to increase or decrease continually. Press the
‘Program’ button to confirm the minute. At any point after 16
seconds of inactivity, the system will exit setting mode and the
time at that point will be saved.
Clock mode, where ‘clock’
indicator is lit
5. Setting the first timer
Users can set a timer to specify when water is to be heated and when the heater will go into energy
saving mode. If users choose not to activate the timer function, toggle the ‘Program’ button until the
‘Timer’ indicator light goes on.
Before setting the timer, ensure the clock is adjusted to the right time. Note that the timer start time is
set first, followed by the end time. Toggle the ‘Program’ button till the ‘Timer’ indicator is lit, then
press and hold down the ‘Program’ button for 3 seconds till the time on the screen flashes. You are
now adjusting the timer start time. Use the “
” and “
” buttons to make 30min increments or
decrements. Press ‘Program’ to finalize the start time and to begin setting the end time. When done,
press ‘Program’ to confirm.
If the timer is set from 20:30 – 22:00, the setting panels should look like these:
14
Timer start time
Timer end time
6. Setting the second timer
The second timer is an added feature that can only be set between the hours of 21:00 – 08:00. The
directions for setting the second timer are the same as setting the first timer. The difference is, to enter
the setting mode, press (but do not hold) the ‘Program’ button while the ‘Timer’ indicator light is off.
Note: None of the timers will work if AES is activated.
