A.O. Smith DURA-Power DRE-52, Инструкция по эксплуатации

Страница: 7 / 20

7
The voltage, element KW, total KW data of the rating plate must be modified by covering them with the label provided in
the conversion kit. Be sure the new ratings on the label match the conversion you have just completed.
Peel off the back of the label and paste over the four lines as shown on the revised rating plate below.
C. Peel off back of caution label and attach label to upper right hand corner of control panel door.
D. CRATE IDENTIFICATION
Using a black magic marker, cross out heater identification on crate as appropriate. In bold letters, write
new electrical specifications in crate, matching those on the revised rating plate.
E. SHIPPING CRATE
Close and tape the plastic flap on front of crate.
CHECK LIST

All affected parts have been installed properly and have been checked for tightness.

All affected wires have been checked for tightness.

New elements have been wired per wiring diagram label on the unit.

New elements have been tightened properly.

New elements have been leak checked.

New rating plate overlay has been installed properly over the existing rating plate.
VIII. MISCELLANEOUS INFORMATION.
A. NON STANDARD CONSTRUCTION
At 480 and 240 volts, 18KW is normally supplied using three 6,000 watt elements. They can however, be
constructed using six 3,000 watt elements.
At 480 volts and 240 volts, 36KW is normally supplied using six 6,000 watt elements. It can however, be supplied
using nine 4,000 watt elements.
SAMPLE RATING PLATE WITH CONVERSION LABEL