A.O. Smith BFC-120, Инструкция по установке, эксплуатации и обслуживанию

Страница: 49 / 126

6.3 Safety devices
6.3.1 Protection for the water heater
6.3.1.1 Water temperature protection
Using temperature sensors T
1
(7) and T
2
(13), the controller monitors three temperatures
that are important for safety. The table explains the functioning of the temperature
sensors.
Safety Description
Anti-frost
(T
1
< 5 ºC or T
2
< 5 ºC)
The frost protection cuts in. The water is heated to
20 °C.
Maximum water
temperature:
(T
1
> 88 ºC or T
2
>
88 ºC)
The high-limit safeguard serves to prevent
overheating and/or excessive formation of scale in
the appliance. If the high-limit safeguard is
activated, heating is stopped. This causes the
water in the tank to cool down. Once the water has
cooled sufficiently (T
1
< 81°C), the controller
resets the appliance.
For extra safety
(T
1
> 93 ºC or T
2
>
93 ºC)
A lockout error of the water heater controller takes
place. (see section 11) The controller must be
manually reset before the appliance can resume
operation. The reset may only be performed if T
1
<
81°C.
6.3.1.2 Storage tank water temperature protection
Using temperature sensors S
2
and S
3
, the solar heating system controller monitors several
temperatures in the storage tank that are related to safety.
Safety Description
Anti-frost
(S
2
, S
3
< 5 ºC)
The frost protection cuts in. The water is heated to
20 °C.
Against overheating of
water:
(S
2
, S
3
> 85 ºC)
The high-limit safeguard serves to prevent
overheating and/or excessive formation of scale in
the storage tank. If the high-limit safeguard is
activated, the heating is stopped. This causes the
water in the storage tank to cool down. Once the
water has cooled sufficiently (S
3
< 78 °C), the
controller resets the water heater.
6.3.1.3 Gas control valve
The controller opens the gas control valve so that gas can be supplied to the burner. As a
safety measure, the gas control valve has two valves. Both valves shut off the gas supply.
6.3.1.4 Fan
The fan (18) provides an optimum air supply when there is a heat demand. As a safety
feature, the fan ensures that any gases present in the combustion chamber are removed,
both before and after combustion. We refer to this as pre- and post-purge.
The fan speed is continuously monitored by the controller (4). The controller takes control
if the fan rpm varies too much from the value set.
6.3.1.5 Pressure switch
The pressure switch only guarantees the supply of air during pre-purging of the water
heater. If the pressure difference during pre-purging is sufficient, the pressure switch
0311753_SGS_28-120_II_UKUK_V2.0 , 2017-05-03 49