NEED HELP? GIVE US A CALL
877.333.7108
INSTALLATION GUIDE
5
1. Pick an appropriate installation location. Unit must be installed in an area where
the main water line enters your home, before connecting to the water heater.
Note: DO NOT install after the water heater or on the hot water line.
Components and installation will vary.
2. Turn off the main water source prior to installation and drain water from lines.
3. Wrap your 3/4" male NPT fittings with NSF certified plumber’s tape. Connect
the 3/4" male fittings to the system’s inlet and outlet.
Note: DO NOT use pipe solvent (dope), as solvents in some types of pipe dope
may cause damage to plastic fittings. Do not over-tighten to prevent damage to
filter head.
1. Using a pipe cutter, cut into the main water supply line to install the shut-off valve.
2. Loosely fit shut-off valve to calculate proper spacing of components.
3. Measure distance for filter head and mark pipe accordingly.
Note: If you’re also installing a bypass loop, do so at this time.
Ensure proper spacing
to fit filter head
Shut-off Valve
Incoming
water supply
Outgoing
water supply
STEP 2
Prepare for Installation
STEP 3
Install Shut-Off Valve
