22
Communication Protocol
and Command Codes
Note:
1. Please disconnect all the twisted pairs before sending command EDIDUpgrade[X].
2. In above commands, “[”and “]” are symbols for easy reading and do not need to be typed in actual operation.
3. Please remember to end the commands with the ending symbols “.” or “;”.
4. Type the command carefully, it is case-sensitive.
5. Commands pertaining to EDID only avails for signal cards that support EDID management.
6. The switcher boasts 6 in-built EDID data, the chart below illustrates the detailed information:
No.
Detailed Information
1
1080p 2D 5.1CH
2
1080p 2D 2.0CH
3
720p 2D 5.1CH
4
720p 2D 2.0CH
5
4K2K 2D 5.1CH
6
4K2K 2D 2.0CH
Update in-built eDID data by sending command UpgradeInteDID[x]..
Examples:
1. Transfer signals from an input channel to all output channels: [x]All.
Example:
Send “3All.” to transfer signals from the input 3 to all output channels.
2. Transfer all input signals to corresponding output channels respectively: All#.
Example:
If this command is carried out, the status of matrix will be: 1->1, 2->2, 3->3, 4->4…… 8->8….
3. Switch off all the output channels: All$.
Example:
After running this command, there will be no signals on all the outputs.
4. Switch off the detail feedback command from the COM port: /:MessageOff;
But, it will leave the “switch OK” as the feedback, when you switch the matrix.
5. Switch on the detail feedback command from the COM port: /:MessageOn;
It will show the detail switch information when it switch. Example: when switch 1->2, it will feedback “AV01 to 02”.
6. Transfer signals from an input channel to corresponding output channel: [x]#.
Example:
“5#.” to transfer signals from the input5 to the output5.
7. Switch off an output channel: [x]$.
Example:
“5$.” to switch off the output 5.
8. Switch signal: [x1] B[x2].
Example:
“12B12,13,15.” to transfer signal from the input12 to the output No.12,13,15.
9. Inquire the input channel to the output channel [x]: Status[x].
Example:
Send “Status3.” to inquire the input channel to the output 3.
10. Inquire the input channel to the output channels one by one: Status.
Example:
“Status.” to inquire the input channel to the output channels one by one.
11. Save the present operation to the preset command [Y]: Save[Y].
Example:
“Save7.” to save the present operation to the preset command No.7.
12. Recall the preset command [Y]: Recall[Y].
Example:
“Recall5.” to recall the preset command No.5.
13. Clear the preset command [Y]: Clear[Y].
Example:
“Clear5.” to clear the preset command No.5.
14. eDID management command:. eDIDM[X]B[Y].
Example:
“EDIDM5B3.” to enable input 3 to learn the EDID data of output 5.
15. Command for signal cards: USeR/[Y]/[X]*****.
Example:
“USER/I/7:0623%;” to set the input 7 to support YPbPr signal, the card is plugged in the second input slot of the matrix.
A
NEU
VIDEO