SPREADER OPERATION
SPREADER OPERATION
SPREADER OPERATION
SPREADER OPERATION
USE SWATH WIDTH ON
PACKAGE OR ADJUST PER
OPERATOR’S WALKING
SPEED
1.
Check the product package for the rate setting,
and recommended swath width. Turn the spreader
off by pushing the control knob in. Rotate the rate
cam to the proper setting.
2.
Always fill the spreader on the driveway or
sidewalk-not on the lawn. Make sure spreader is in
the “OFF” position. Empty after each use.
3.
Start spreader moving, then open spreader by
pushing the thumb release to the “ON” position.
Always push spreader, never pull. Push knob down
to close spreader.
4.
Hold handle so top of spreader is level. Tipping the
spreader too far can cause uneven spreading.
5.
The settings and swath widths on the product label
are recommended starting points. Always check the
delivery rate and pattern on a small area before treating
a large area. Actual delivery rate can vary due to
weather conditions, operating variables, and condition
of the product being applied. See “HOW TO
DETERMINE SPREADER SETTING AND SWATH
WIDTH” for details.
6.
Push spreader 3 1/2 m.p.h. (26 feet in 5 seconds)
for full 8’ to 10’ spread pattern when applying
fertilizer products. Apply header strips at each end of
area to be treated then space trips across the area
as shown.
7.
Push spreader at 2 1/2 mph (18 feet in 5
seconds) to reduce width of spread when applying
ice melt products to sidewalks.
ON
8.
Empty spreader after each use. Return leftover
material to its original container.
4
