CAUTION: ONCE KNOB IS LATCHED,
DO NOT MOVE THUMB RELEASE UNTIL
YOU HAVE COMPLETED STEP #5.
Control Knob &
Wire Assembly
Spring
Thumb
Release
1/4-20 x 2 1/4”
Bolt & Washer
1/4-20 Hex
Nut & Washer
Remove Caution
Label
4.
Feed control knob/wire through the
T-handle until spring touches the round
hole. CAUTION: Do Not Compress Spring
At This Time.
Feed wire through the
square handle tube. Be sure wire passes
above the bolts in the handle brace.
Secure T-handle to the tube with (1) 1/4-20
x 2” hex bolt. (2) washers, and (1) hex nut
in the bottom hole, and (1) 1/4-20 x 2 1/4”
hex bolt, (2) washers, and (1) hex nut in
the top hole as shown. Remove caution
label and push the thumb release toward
the center and push down knob and shutoff
spring until knob latches.
5.
Slide wire retaining clip onto wire as shown.
Insert wire through hole shutoff plate. Slide wire
retaining clip over shutoff plate and wire until the
clip locks into place.
6.
Install gear cover assembly over gears and secure
with (2) #6-32 screws. Slide handle grips onto handle.
Soapy water will ease installation. (Do not use
petroleum based products.) The AM 50P spreader
should now be completely assembled and ready for
use.
Wire Clip
Shutoff Plate
Wire
#6-32 Screw
#6-32 Screw
ASSEMBLY, CONTINUED
ASSEMBLY, CONTINUED
ASSEMBLY, CONTINUED
ASSEMBLY, CONTINUED
Handle Grip
Handle Grip
3
