![background image](http://html.mh-extra.com/html/a-j-antunes/roundup-hdh-3/roundup-hdh-3_owners-manual_447195006.webp)
6
P/N 1010736 Rev. H 11/15
INSTALLATION
Unpacking
1. Remove unit and all packing materi-
als from shipping carton.
2. Open the large box. Remove all
packing materials and protective
coverings from the unit and parts.
NOTE:
If any parts are missing or dam-
aged, contact A.J. Antunes & Co.
IMMEDIATELY at 1-800-392-7854
(toll free in the U.S. and Canada)
or at 630-784-1000.
3. Wash all components in soap and
water. Wipe all surfaces of the unit
with a hot damp cloth.
NOTE:
Do NOT use a dripping wet cloth.
Wring out before use.
4. Install components in unit.
Equipment Setup
When placing the unit into service, pay at-
tention to the following guidelines.
y
Make sure power is off and the
unit is at room temperature.
y
Do NOT block or cover any
openings on the unit.
y
Do NOT immerse cord
or plug in water.
y
Keep cord away from heated surfaces.
y
Do NOT allow cord to hang over
edge of table or counter.
y
Place unit on a sturdy, level
table or work surface.
Ensure that the line voltage corresponds to
the stated voltage on the unit specification
label.
Ensure the power to the unit is turned off
before plugging in the power cord.
NOTE:
The power cord for Mfg. No.
9300132 is located on the left
side of the unit. See note on page
11.
BASKET
TRAY
BULKHEAD
RACKS
CAUTION
All electrical connections must be in
accordance with local electrical codes
and any other applicable codes.
WARNING
y
ELECTRICAL SHOCK HAZARD.
Failure to follow the instruc-
tions in this manual could result
in serious injury or death.
y
Electrical ground is re-
quired on this appliance.
y
Do NOT modify the power sup-
ply cord plug. If it does not fit
the outlet, have a proper outlet
installed by a qualified electrician.
y
Do NOT use an exten-
sion cord with this unit.
y
The unit should be grounded ac-
cording to local electrical codes to
prevent the possibility of electri-
cal shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating.
y
Check with a qualified electrician
if you are unsure if the appli-
ance is properly grounded.
Figure 1. Hot Dog Hutch Components (HDH-3 Shown)
Содержание Roundup HDH-3
Страница 10: ...10 P N 1010736 Rev H 11 15 LIGHT WIRING DIAGRAM ...
Страница 17: ...17 P N 1010736 Rev H 11 15 NOTES ...
Страница 18: ...18 P N 1010736 Rev H 11 15 NOTES ...
Страница 19: ...19 P N 1010736 Rev H 11 15 NOTES ...