1-877-392-7854 Fax: 630-784-1000
Page 2 of 2
P/N 1011049 Rev. A 02/10
Sonic
A. J. ANTUNES & CO.
180 Kehoe Blvd., Carol Stream, Illinois 60188
INSTAllATION INSTrUCTIONS
SONIC fry STATION TImEr EST-3 (mfG. #9900651) & EST-3lS (mfG. #9900652)
f. Use a Phillips screwdriver to screw two #8-18 x
1/2” lg. self-tapping screws into the stainless steel.
Do NOT overtighten the screws. Allow space for the
brackets to fit over the screws.
g. Mount the bracket onto the screws and then finish
tightening the screws with the Phillips screwdriver.
h. Re-install the Timer onto the Mounting Bracket.
i. Place a lock washer on the inside and outside of
each side of the Mounting Bracket and then secure
in place with the thumb screws.
Using the fry Station Timer
The Fry Station Timer is pre-programmed at the factory
with the following values:
Description
& Value
Default
Setting
max Setting
Tots
10 minutes
99 minutes,
59 seconds
French Fries
10 minutes
99 minutes,
59 seconds
Onion Rings
10 minutes
99 minutes,
59 seconds
1. Press the ► button (Figure 3) for the desired prod-
uct and the timer will begin counting down.
2. When the timed cycle is complete, the display
flashes “00:00”, the blue light will flash once every
second, and the unit will beep (EST-3LS only).
NOTE: After two minutes, the blue light will flash
once every two seconds, and the unit will stop beep-
ing (EST-3lS only). After five minutes, the blue light
will stop flashing.
3. Press the
■
button (Figure 3) to stop and reset the
Timer.
NOTE: If the display is faded, or if the volume is too
low (EST-3lS only), the three AA backup batteries
should be replaced.
limited Warranty
The Fry Station Timer (EST-3 and EST-3LS) has a 90-day warranty from date of purchase. This warranty does not cover
misuse/abuse, damage due to dropping, cover damage, and/or cracked solar panels. The warranty for this timer does
not cover travel time or mileage. Contact the Technical Service Department at the factory for any warranty issues.
figure 3. fry Station Timer (EST-3lS shown)
Programming the fry Station Timer
1. Press and hold the
►
button for the desired product
for three seconds.
2. The minutes setting will flash on the display. Use
the ► and
■
buttons (Figure 3) to raise and lower
the setting.
3. Release the buttons when the desired minutes
setting appears on the display.
4. The seconds setting will flash on the display. Use
the ► and
■
buttons to raise and lower the setting.
5. Release the buttons when the desired seconds
setting appears on the display.
6. Wait three seconds without pressing any buttons.
The new settings will be stored and the display will
go blank.
Problems with the Timer?
If you experience any problem with your Timer, contact
the manufacturer immediately at 877-392-7854.
NOTE: A replacement battery cap can be obtained
through your Authorized Service Agency by ordering
P/N 7000573.
