A.J.Antunes HCT-5H, Руководство пользователя

Страница: 13 / 24

HCT-5H BUN TOASTER
13
A.J. Antunes & Co.
P/N 1011256 Rev. B 03/15
McDonald’s
TROUBLESHOOTING (continued)
Problem Possible Cause(s) Corrective Action
Display Reads “Heater
A Fail”
The Platen Heater A heater did not reach
set-point temperature.
Cycle Power OFF/ON. If message persists,
then Call AJA Technical Support 877-392-7854
for assistance.
Display Reads “Sensor
A Fail”
Platen Thermocouple A sensor has
failed.
Display Reads
“Overtemp B”
Platen B heater is overheating &
exceeded its set-point.
Display Reads “SSR
B Fail”
The solid state relay for Platen B has
failed.
Display Reads
“System B Fail”
The Platen Heater B heater did not
reach set-point temperature.
Display Reads “Platen
B Low”
The Platen heater B heater has dropped
below the set-point temperature after
achieving set-point but cannot recover.
Display Reads “Heater
B Fail”
The Platen Heater B heater did not
reach set-point temperature.
Display Reads “Sensor
B Fail”
Platen Thermocouple B sensor has
failed.
Display Reads
“Overtemp C”
Platen C heater is overheating &
exceeded its set-point.
Display Reads “SSR
C Fail”
The solid state relay for Platen C has
failed.
Display Reads
“System C Fail”
The Platen Heater C heater did not
reach set-point temperature.
Display Reads “Platen
C Low”
The Platen heater C heater has dropped
below the set-point temperature after
achieving set-point but cannot recover.
Display Reads “Heater
C Fail”
The Platen Heater C heater did not
reach set-point temperature.
Display Reads “Sensor
C Fail”
Platen Thermocouple C sensor has
failed.
Display Reads “USB
Power”
An unauthorized device has been
plugged into the rear USB Port that is
over loading the USB port.
Remove the device from the port. NOTE: Only
approved devices for special toaster software
loading should be used. Call AJA Technical
Support 877-392-7854 for assistance.