A.J.Antunes 9200500, Руководство пользователя

Страница: 17 / 28

RAPID TOASTER VCT-200
17 P/N 1010710 Rev. N 02/13
McDonald’s
Problem Possible Cause Corrective Action
Conveyor Belt/Chain
does not turn or skips
sprockets.
Compression Knobs. Set the Bun Thickness Compression Controls to “D
& 5” for 17 second toasters. For 10 second toast-
ers, set the controls to “B & 3” (see Figures 2A &
2B).
Interlock Switches not Activating. Verify the Covers are installed correctly. Repair or
replace damaged conveyor inner cover.
Switches are inoperable - Contact your
Maintenance person or an Authorize Service
Agency for service.
Conveyor Chain Stretched. Open Conveyor Covers. Set Compression Knobs
to 6 and F. Facing the Heel/Club side, locate the
approximate center point of the Groovy Belt Wrap.
Pull the Conveyor Chain away from the edge of the
toaster. Stand a U.S. Quarter coin (15/16” - 2.5
cm) on end between the frame and the chain. If
the gap is significantly greater, REMOVE link(s) -
Refer to the Maintenance section of this manual. If
you cannot stand a coin in the gap, you may have
to ADD a link. Duplicate the procedure for the
Crown
side using a U.S. Dime coin (11/16” - 1.8
cm).
Roller Tensioner bent or missing.
IN
G
O
D
W
E
T
R
U
ST
LIB
E
R
T
Y
- 2
00
0
Adjust bent Roller Tensioner - measured to 13/16”
(2.1 cm) or the height of a U.S. Nickel coin from
the bottom of the roller to the inner cover.
Note: Damaged Roller Tensioners should be
replaced.
Motor Drive Chain is off or dry. Have a maintenance person or your Authorized
Service Center reinstall and/or lubricate the chain,
inspect all electrical connections and, if necessary,
replace motor..
Motor drive does not operate.
Groovy Belt Wrap(s) stop
turning, but Conveyor
Chain continues to turn
Underside of Groovy Belt Wrap(s)
and Conveyor Chain have exces-
sive carmelizing buildup.
Clean Belt Wrap and Chain as per current MRC,
TS 019.
Flap covering Connecting
hinge or wavy rib on belt
wrap is getting torn or
worn.
The inner Conveyor Cover is
damaged
Repair or replace the inner Conveyor Cover.
Groovy Belt Wrap is installed
upside down.
Reinstall Belt Wrap with flap down.
Belt Wrap(s) are tearing
in center.
Missing or bent
Roller Tensionoer(s).
IN
G
O
D
W
E
T
R
U
ST LIB
E
R
T
Y
- 2
00
0
Replace or adjust bent Roller Tensioner - mea-
sured to 13/16 (2.1 cm) or the height of a U.S.
Nickel coin from the bottom of the Roller to the
inner back cover.
TROUBLESHOOTING (continued)