7
P/N 1010698 Rev. I 03/12
operaTinG inSTrUcTionS
NoTE: Steam generator must be cali-
brated before initial use. See the section
titled Calibration in the Installation sec-
tion of this manual.
1. Turn the power on and allow the unit to
preheat for approximately 20-30 min-
utes (Figure 6).
NoTE: The green ready Light (Figure 6)
will flash during warm-up. The flashing
light will become steady when the unit
is up to temperature. If the green ready
Light continues to flash after warm-up, or
starts to flash during operation, see the
Troubleshooting section in this manual.
NoTE: Do NoT push the CYCLE STarT
button during warm-up. The flashing
green ready Light indicates unit is not
up to temperature. If the CYCLE STarT
button is pressed while the green light is
flashing, nothing will happen.
2. Pull out the Spatula and place the
product to be steamed onto the
Spatula.
3. Push the Spatula fully into the
steamer.
4. Press and release the
cycle STarT
button The Green Ready Light will go
out and the Yellow Steaming Light will
come on and remain lit for the entire
steaming cycle.
5. At the end of the steaming cycle
(approximately 7 seconds), an audible
signal will sound for 3 seconds and
the Green Ready Light will come back
on, indicating the product is ready to
be served.
6. Carefully remove the steamed product.
WarNINg
To avoid injury, use caution when pulling
the Spatula out from unit. Be sure to allow
steam to escape before putting hands or
face over the steamer.
START
CYCLE
STEAMING
READY
TM
POWER
R
Figure 6. TBS-1X operating Controls
Yellow Steaming Light
green ready Light
power Switch
Cycle Start Button
Hi-limit tHermostat
A hi-limit thermostat will turn off electrical power to the generator and Transformer circuits if the
unit overheats. Turn unit off and allow to cool; the hi-limit thermostat will automatically reset
when the unit cools down. If the unit continues to shut off due to overheating, contact your
Roundup Authorized Service Agency.
