5
4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
The correct power tool will
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the power tool is maintained.
Additional safety rules for sanders
Before connecting a tool to a power source (mains switch
power point receptacle, outlet, etc.) be sure that the voltage
supply is the same as that specified on the nameplate of
the tool. A power source with a voltage greater than that
specified for the tool can result in serious injury to the user,
as well as damage to the tool. If in doubt, do not plug in
the tool. Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the sanding belt.
•
Fully unwind cable drum extensions to avoid potential
overheating.
•
When an extension cable is required, you must ensure
that it has the right ampere rating for your power tool and
is in safe electrical condition.
•
After long working periods external metal parts and
accessories could be hot.
•
If possible, always use clamps or a vice to hold
your work.
•
Always switch off before you put the sander down.
•
Do not force the sander; let the tool do the work at a
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient sanding and possible damage to the
sander motor.
•
When sanding wood, always connect the dust bag or use
a dust extraction system.
•
Before using the sander with metal, always remove the
dust bag from the outlet as sparks may ignite the dust or
the bag.
•
Do not continue to use worn, torn or heavily clogged
sanding belts.
•
Do not touch the moving sanding belt.
Содержание TS900
Страница 11: ......
