909 PLD5020A, Инструкция по эксплуатации

Страница: 6 / 8

6
2. To decrease the paint flow, turn the Paint Volume Control dial
to the right. (refer Fig 5).
Using the Flexible Nozzle
NOTE: Ensure the product is NOT connected to the mains power
before changing the nozzle on the sprayer.
The flexible nozzle is best used for painting ceilings, resting
objects or hard to reach places.
1. Remove the ceramic nozzle fitted onto the paint sprayer by
turning it anti-clockwise. (Fig. 6)
NOTE: Do not remove the spring valve assembly
2. Using the external threaded end of the flexible nozzle, place
the flexible nozzle over the spray tip assembly and then thread
in the flexible hose by turning clockwise. (refer Fig. 7)
3. When the flexible nozzle is securely fitted to the sprayer, you
can adjust the direction of the nozzle to point to the position
required for use.
Changing a nozzle
An additional Ceramic nozzle (4) has been supplied with this
product.
Note: Ensure the product is NOT connected to the mains power
before changing the nozzle on the sprayer.
1. Remove the nozzle on the paint sprayer by turning it in an anti-
clockwise direction until it can be removed.
Note: Be careful not to remove the Spring Valve assembly
located behind the ceramic nozzle. (refer Fig 8)
To replace the Spring Valve assembly, refer to the next section.
2. Attach the new nozzle by placing it over the spring valve
assembly and turning it in a clockwise direction until it is
secure.
Replacing the Spring Valve assembly
An additional Spring Valve assembly (5) has been supplied with
this product.
Note: Ensure the product is NOT connected to the mains power
before changing the spring valve assembly on the sprayer.
1. Remove the nozzle on the paint sprayer by turning it in an anti-
clockwise direction until it can be removed.
2. Remove the Spring Valve assembly (refer Fig 8).
3. Insert the new Spring valve assembly with the white tip end
going in first.
4. Replace the ceramic nozzle
over the spring valve assembly
and secure the ceramic nozzle
by turning it in a clockwise
direction.
Cleaning and Maintenance
IMPORTANT: The spray gun can only operate satisfactorily if it is
cleaned and preserved after each use.
If the spray gun is not cleaned properly after each use, the gun
will not perform correctly the next time of use. Failures due
to improper cleaning and maintenance are not covered under
warranty.
WARNING: Never immerse
the spray gun in liquid
when cleaning.
1. Empty out the remaining paint
from the container. Wash out
the paint pot to clear any paint
residue. Discard cleaning fluid.
2. Put proper thinner in the
container and trigger the
sprayer for approx. 5 seconds.
3. Disconnect the sprayer from the
mains power.
4. Use the small nozzle from the flexible nozzle extension
assembly as a nozzle spanner. From the flexible nozzle,
unscrew the nozzle end cap. (fig 9a)
NOTE: Do not lose the small plastic valve in the flexible tube.
Fit the nozzle end cap onto the valve assembly on the spray gun
by approx. 6 turns. (fig 9b)
Fig. 9
Fig. 7 Fig. 6
Fig. 8