909 PLD5020A, Инструкция по эксплуатации

Страница: 4 / 8

4
6
3
3
2
1
12
4
7
Know your product
1. On/Off switch
2. Paint volume control dial
3. Air vent
4. Ceramic nozzle
5. Spring Valve assembly
6. Paint filter
7. Paint Pot
8. Paint Pot lid (additional pot only)
9. Flexible nozzle
10. Viscosity Cup
11. Nozzle Cleaner/Cleaning Needle
12. Handle
13. Valve/Pump Assembly
Assembly
The PLD5020A Paint Sprayer does not require any
pre-assembly before use.
What substances can this Paint Sprayer be used with?
The following substances are suitable for use with this Paint Sprayer:
• Oil and water based paints
• Paints and varnishes containing solvents
• Acrylic enamel paints
• Water-soluble varnishes
• Glazes & polishes
• Wood preservatives, disinfectants, plant protectives & saturants.
DO NOT use the following:
• Dispersion and latex paints
• Materials containing strong abrasives,
• Glazes with coarse particles,
• Strippers and caustic solutions,
• Silicate paints.
Note: The use of these spray materials can lead to increased
wear or corrosion damage in the pump area of the sprayer,
which is not covered by warranty.
Preparation of Spray Material
Most paints will require dilution before using with your Paint
Sprayer. Refer to the guidelines in the viscosity table below for
the recommended required dilution. The correct dilution can be
achieved by using the viscosity test cup supplied with your paint
sprayer. (Note: Viscosity = consistency of the paint).
11
9
4
7
8
5
10
13
5