909 909210TS, Инструкция по эксплуатации

Страница: 16 / 18

16
3. Press the work piece firmly against the mitre gauge.
4. Switch ON the saw.
5. Push the mitre gauge and the work piece toward the
saw blade in order to make the cut.
IMPORTANT. Always hold the guided part of the work
piece. Never hold that part of the work piece, which is
being cut off.
Always push the mitre gauge far enough forward for the
work piece to be cut through completely.
Switch off the saw again. Wait for the saw blade to stop
before you remove the off-cuts.
Replacing the saw blade
CAUTION. Switch off the machine and remove the
mains power plug before carrying out any adjustments,
maintenance work or blade changes.
1. Turn the blade depth adjustment wheel (10) until the saw
blade is at the maximum cutting depth.
2. Remove the 4 screws from the side panel.
3. Remove the 4 screws from
the blade cover side panel,
and angle the pin from the
track. Put to one side.
4. Use a small 8mm
open-ended spanner to
hold the spindle fast.
5. Use a second 19mm
spanner to undo the blade
nut by turning in an anti-
clock-wise direction (right
hand thread).
6. Remove the nut and outer flange and then take the blade
from the shaft.
7. Carefully clean the saw blade flange before you fit the
new or re-sharpened saw blade.
8. Insert and secure the saw blade in reverse order.