8i 210820, Инструкция по эксплуатации

Страница: 28 / 32

EN
Installation of Motor with built-in re Remote Rontrol Topline – Mono Beds
120 + 140 cm
Please connect the remote controls correctly for a proper use of the motor with built-in
receiver.
Important: In the case of a MONO bed, only one of the two motors has to be
connected to the remote control. After connecting the synchro cable, both
motors are controlled together.
Connecting or linking of the remote control to the motor can be done in 2 different
ways:
• Automatic connecting mode:
o Plug the 220V power plug of 1 motor to the mains.
o After connection to the main power, the white LED lights of the motor
will light up and the receiver enters in an automatic connecting mode.
o
You now have 60 seconds to connect the remote control.
o Press the remote buttons 1 & 2 (first row) TOGETHER.
o On the motor, the white LED flashes 2 x and goes out (the blue LED
flashes for another 60 seconds). The connection between remote
and receiver was successful.
o
Note: sometimes the connection can take more than 10
seconds!!
o It’s necessary that a reference movement is now performed. Now
keep the connecting button A pressed. Both motors (Head and Foot)
are moving to their Zero Position. When the white LED light on the
motor flashes 2 x, the reference movement was successful.
o Connect the 220V of the 2nd motor also perform the reference
movement as described above.
o Now connect the supplied synchro cable to both motors.
o
The adjustable bed is now ready to be used - both motors are
controlled by 1 remote control.
• Manual connecting mode:
o After the 60 seconds mentioned above the receiver leaves its
automatic connecting mode; the white LED lights go out and a
manual connecting mode has to be activated.
o On the motor, press 2 x the connecting button A until the white LED
lights will light up.
o You now enter the manual connecting mode.
o
Continue the connection as in the automatic connection mode.