Flight Modes
Flight Modes
Code Binding
Notes: If drone receives no instruction for 10 minutes while powered on, it will emit an alarm
sound, which is normal. You could either unlock the motors or turn off the battery to stop that
sound and then try starting again.
Press and hold the power button and
backward button to start code binding.
Code Binding
Preparations Pre-fly
Follow Tracker
Signal connected
Connection distance less than 1 meter
(Please take it by your side)
1
2
3
Bind code ... 0
NET ID:XXX
Bind code Begin
Disconnect
Disconnect
Disconnect
Watch
Hawk 4K
The drone, watch and tracker are all linked by default initially. Here is the
trick about code binding just in case that those devices are new to each
other.
Drone to watch: Plug a small connector into two short needles on the
gimbal mount to make a short circuit. Power the drone and immediately
remove the connector. Then press the power button and backward button
of watch at the same time and hold them for a few seconds while the
watch is binding the code of the drone. The watch will get connected
with the drone when the screen shows the control interface.
Watch to GPS tracker
：
Turn on the watch and GPS tracker. Insert a needle
into a hole on the tracker’s back. The blue LED will start to flash blue. The
tracker will get connected to the watch when the LED is steady on and the
follow GPS signals on the watch show 0.
1. Place the drone on a flat platform and turn on the battery by pressing
& holding the power button on the tail. The drone will immediately start
self-checking when the front red LEDs lights and rear blue LEDs start
flashing quickly.
2. When the blue LED slowly flashes and the aircraft gives out a Di-Di
sound, it indicates the checking of fly control system is completed.
3. When the gimbal is level and the aircraft gives out another Di-Di sound,
it indicates that the gimbal is ready.
4. Turn on the watch by pressing & holding the power button on the top.
In a few seconds the watch will get connected to the aircraft when the
screen shows the control interface. Wait until the drone gets at least 10
gps satellites and an icon of “ ”shows on the watch before take-off. If
the satellites are weak or unstable, try it at another place. To turn off the
watch, also press & hold the power button.
5. Turn on the GPS tracker by pushing the button on the top, wait until 7
satellites are collected and an icon of “ ” shows on the watch before
starting follow me flight.
