6Harmonics GWS-3000, Руководство по эксплуатации

Страница: 25 / 31

@2013 6Harmonics Inc. All Right Reserved 25
The actual channel which is used must be part of both the “chanlist” and the
“subchanlist”. The “chanlist” is from the database while the “subchanlist” is from
the installer and used to configure hardware limitations such as a narrow band filter
which is inline with the antenna. The Software will only attempt to use a channel
which are part of both lists.
By default, the “subchanlist” includes all channels for a given market. For the USA
this would be channels 14-35, and 39-51. To restrict this further the professional
installer must rewrite the subchanlist.
Ensuring that the “subchanlist” is properly programmed will improve network
performance by ensuring nodes do not try to transmit at frequencies for which an in-
line filter or combiner might be attenuating the signal.
7.21 getsubchanlist command
The “getsubchanlist “ is used to read the sub channel list
7.22 cu command
The “cu” command is to set tx power up 5 dBm
7.23 cd command
The “cd” command is to set tx power down 5 dBm
Note: The “Cu” and “cd” commands are to perform course power adjustments in the
field and can be used to adjust transmit power while a node is in service. The
software will only allow the user to increase the power up to the limit allowed by the
regulatory standard in a given market. For the GWS-3000 in the US, this is 20
dBm.
7.24 setagcmode command
The “setagcmode” is to set the Receiver AGC mode. The choices are 0, 1,
and 2.
GWS Cmd >setagcmdoe 2