4ms Company Mini PEG, Руководство пользователя

Страница: 10 / 12

The ENV OUT and 5V ENV lights show the current threshold. Each light can be one of five possible
colors: off, blue, purple, red, white. Off is the lowest value and white is the highest value. There are 25
possible values. The ENV OUT light is weighted more than the 5V ENV light.
The lowest threshold is represented by both lights being off. The next higher threshold value is when
ENV OUT is off and 5V ENV is blue. The highest value is when both lights are white.
The module starts bootloader mode with the threshold near the middle of the range: both lights purple.
Each time you press Cycle, the threshold will increase and the lights will change. Once you get to both
lights being white (highest threshold), it will cycle back around to both lights being off (lowest threshold).
If you have trouble loading a firmware file and have already tried a different device and checked your
volume, then adjusting the threshold may help. The best approach is to try different values until you find
one that works.
Troubleshooting
• Make sure the volume on your device and app are at 100%.
• Try a different computer or device.
• Do not use sophisticated playback software such as Ableton, as these can inadvertently alter the
encoded audio. Use the most basic playback program available.
• Adjust the threshold (see above)
• If you have an oscilloscope or a way to view waveforms, compare the output of the EOF jack
with the output of the computer or device. Adjust the threshold using the Cycle button until the
pulses are similar (accounting for about 40 µ s-80 µ s of latency, and of course amplitude
differences).
• Use a line-to-Eurorack module, such as the Listen IO , between the computer and the Mini PEG .
Viewing the Firmware Version
On power-up, the Mini PEG displays its firmware version by flashing two colors on the Ping button.
The first color turns on immediately after power-up, then the light turns off for a moment and the second
color turns on. As of this manual printing, the latest (and only) version number is 1.0.
Red, then White = 1.0
System Mode
System Mode allows you to change the way the Mini PEG works. To enter System Mode, hold down
the Cycle button for 3 seconds. When the lights flash to confirm entry into System Mode, release the
button.
You can exit System Mode at any time by holding down either the Ping button or the Cycle button for 3
seconds. If you exit with the Cycle button, your changes will be active but will not be saved after you
power down (the previous saved values will be restored). If you exit with the Ping button, your changes
will be saved.
If you enter System Mode with Cycle on, the envelope will continue to cycle while you remain in
System Mode, but you will be unable to adjust its parameters.
Saving the Clock Time and Cycle State
The ping clock period and the state of the Cycle button can be saved so that the next time you power-
on, the Mini PEG will load the saved values.
If you are using an external clock patched into the Ping jack or received over Clock Bus, the tempo of
that clock will be saved. If you tapped a tempo on the Ping button, that tempo will be saved. In either
case the tempo before Div/Mult is applied will be saved.
Whether or not the module is cycling will also be saved. If the Cycle button is illuminated at the moment
you enter System Mode, then the module will turn Cycle on when you next power-on.
First Color Second Color Version
Red White 1.0
Page of 10 12