1
2
3
4
1
2
3
4
1
2
3
4
Warning
Runaway return: When the signal of the remote controller is interrupted for
about 4s, the aircraft will automatically return to the place where there is a
signal and stop. Low battery return: when the aircraft is in low battery electricity,
it will forcefully return to a place that is 20m above the take-off point. The return
flight cannot be cancelled during the low battery return.
13.4 Waypoint flight mode
①
In GPS mode, click the "More Functions" icon (Figure 20) in the APP control interface to
enter the multi-point flight (Figure 21). At this time, the interface changes from the image
transmission page to the map page. On the map page, click to set the track range of the
segmented waypoints or continuous waypoints (Figure 22). During the setting, if the track
waypoints are too dense, you can click the delete icon to delete all the waypoints (Figure 23).
②
After setting of the waypoint, click the send icon (Figure 24), the aircraft will fly to all
waypoints from the initial point to complete the preset flight trajectory. The direction of the
aircraft can be controlled by the joystick during the flight.
Figure 29
Figure 30
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Figure 23
Figure 24
Figure 22
13.3 Speed switching
When the aircraft takes off, it is by default in the low-speed mode (3-geared switching);
gently press the remote control by a "beep" sound for low-speed gear, two "beep" sounds for
medium-speed gear, and three "beep" sounds for high-speed gear (Figure 17)".
APP operation: Click the "More Functions" icon (Figure 18) in the APP control interface, and
the flight speed can also be switched (Figure 19).
13
