4B - W4005 BÜHLER ELEVATOR MONITORING SYSTEM R9.6 – 22 May 2020
Page
16
of
48
IMPORTANT:
DO NOT REMOVE THE WHIRLIGIG® TARGET GUARD COVER. THE ROTATING COMPONENTS
UNDER THE COVER COULD CAUSE SERIOUS INJURY.
8.3
ADB910V3AI /B - Adjustable Depth Bearing Temperature Sensor
a)
Remove the existing grease nipple from the bearing sensor
b)
Drill out and tap to 1/8”
Rp (BSPT) x 6mm deep if needed
c)
Slacken the olive nut and remove the sensor probe
d)
Screw the sensor body into the new tapped hole in the bearing housing
e)
Re-insert the temperature probe in to the olive nut adjusting the depth to suit the bearing depth
f)
Tighten the olive nut using an appropriate spanner
g)
The maximum recommended torque for the olive nut is 2N-m (18 lb-in). Please do not exceed.
Figure 6 – P300 and Whirligig Mounting Bracket Mechanical Installation
Содержание W4005V46-SYS/B Series
Страница 45: ...4B W4005 B HLER ELEVATOR MONITORING SYSTEM R9 6 22 May 2020 Page 45 of 48 This page is intentionally left blank...
Страница 46: ...4B W4005 B HLER ELEVATOR MONITORING SYSTEM R9 6 22 May 2020 Page 46 of 48 This page is intentionally left blank...
Страница 47: ...4B W4005 B HLER ELEVATOR MONITORING SYSTEM R9 6 22 May 2020 Page 47 of 48 This page is intentionally left blank...
