3xLogic VISIX S-Series, Руководство по установке, Страница: 9 / 110

Installation Manual v3.1 | VISIX S-Series Network Camera
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC 8
1 Introduction
The network camera is an embedded digital surveillance camera that combines the features of both the
traditional analog camera and the encoder. With a built-in video server, the network camera is capable of
providing real-time video stream compression, processing, video analysis and transmission simultaneously.
Adopting the latest processing chip and hardware platform, the network camera can be widely applied to
various surveillance and image processing systems with high reliability and stability. Please see Section 2 of
this guide for help locating the section of the manual that pertains to your specific camera.
1.1 Applications
The network camera can be used in many surveillance scenes., e.g.:

Network surveillance for over-the-counter activities in banks, ATMs, supermarkets and factories.

Remote surveillance systems for nursing homes, schools, casinos, hotels, jails, etc.

Artificially Intelligent access control systems.

Artificially Intelligent office building/residential compounds management systems.

Unguarded power station, toll road and telecommunication base station surveillance systems.

Warehouse monitoring systems.

Surveillance systems for airports, railway stations, bus stops, etc.
1.2 Preparations

Make sure the device in the package is in good condition and all the assembly parts are included.

Make sure all the related equipment is powered off during installation.

Check the specification of the products for the installation environment.

Make sure the power supply is matched with your required voltage to avoid damage.

If the product does not function properly, please contact your dealer or the nearest service center. Do not
disassemble the camera for repair or maintenance by yourself.

Make sure that the wall is strong enough to withstand three times the weight of the camera.
NOTE: For cameras that support IR, please adhere to the following precautions to prevent IR reflection:

Dust or grease on the dome cover will cause IR reflection. Please do not remove the dome cover film until
the installation is finished. If there is dust or grease on the dome cover, clean the dome cover with clean
soft cloth and isopropyl alcohol.

Make sure that there is no reflective surface too close to the camera lens. The IR light from the camera
may reflect back into the lens causing reflection.

The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate the
lens from the IR LEDS. Fasten the dome cover to camera body so that the foam ring and the dome cover
are attached seamlessly.