16
Delete handheld transmitter:
Attention!
Deleting the handheld transmitter
deletes all paired transmitters on the radio motor.
The motor confirms
the programming
with several
beeps
OK
1 x Press button
P2 / Set Up
1 x Press
Stop-button
Beep while
pressing
Leave Power supply
switched on.
Only switch the affected
motor to voltage.
1 x Press button
P2 / Set Up
Beep while
pressing
Switching the operating mode
Shutter and Blind:
The motor confirms
the programming
with several
beeps
OK
1 x Press button
P2 / Set Up
1 x Press
Up-button
Beep while
pressing
Leave Power supply
switched on.
Only switch the affected
motor to voltage.
1 x Press button
P2 / Set Up
Beep while
pressing
This setting allows switching from Shutter mode and Blind mode and vice versa.
Shutter operating mode:
Motor immediately goes into self-hold when a direction button is pressed.
Blind operating mode:
Jog mode possible. Only when the direction key is pressed for longer than 2 sec. Self-holding is carried out.
Note:
The following 3T-MOTORS transmitters do not have a P2 / Set Up button:
Radio wall transmitter
WS1
Radio wall transmitter
WS2
Radio wall transmitter
WSE2
Radio timer
WSTF1
Radio timer
WSTF5
Radio mini transmitter
FMSF
Button combination:
Press Up + Stop buttons simultaneously (FMSF / WS1 / WS2 / WSE2).
Press the Set and Mode buttons simultaneously (WSTF1 / WSTF5).
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the motor returns to its original state.
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the motor returns to its original state.
3T-MOTORS Radio tubular motors
| Programming radio transmitter
PROGRAMMING RADIO TRANSMITTER