20
3T-MOTORS Tubular motors 12V
| Installation instructions
INSTALLATION INSTRUCTIONS
1. Setting the position „EXTEND”
•
Set the switch to „EXTEND”, awning moves OUT.
•
Run the tubular motor in the „EXTEND” direction until the end switch-off occurs.
•
If the motor is to continue moving, turn the adjustment pin on the „EXTEND” limit switch screw in the PLUS direction until the desired position is reached.
2. Setting the position „RETURN”
•
Set the switch to „RETURN”, awning moves IN.
•
Run the tubular motor in the „RETURN” direction until the end switch-off occurs.
•
If the motor is to continue moving, turn the adjustment pin on the „RETURN” limit switch screw in the PLUS direction until the desired position is reached and
the awning is fully retracted.
If the awning motor travels too far:
•
While the tubular motor is moving in the relevant direction (EXTENDING or RETURNING), turn the adjusting pin on the relevant limit switch screw in the MINUS
direction until the tubular motor switches off. If this is not possible, stop with the switch.
•
After switching off by turning the limit switch screw in the PLUS direction, allow the tube motor to move to the desired end position.
•
If this does not work, run the tube motor again in the opposite direction, stop and repeat this procedure.
Adjustment pin is required
