6
PROGRAMMING
The internal battery must be charged before programming.
Perform programming before mounting the motor and solar module.
One transmitter can control up to 20 solar modules. Receiver stores a maximum of 20 transmitters (channels).
1 x Press button
P2 / Set Up
Pairing of handheld transmitter to
SP50 solar module:
Press and hold program
button for 2 sec.
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the system returns to its original state.
Tubular motor
starts 1 x
Release
programm button
LED indicator
flashes 1 x
LED indicator
flashes 1 x
1 x Press button
P2 / Set Up
1 x press Up-button
Transmitter is paired
Up-button controls
motor forward
OK
or
1 x press Down-button
Transmitter is paired
Down-button controls
motor forward
OK
LED indicator
flashes 1 x
Tubular motor starts 1 x,
LED indicator flashes 4 x
Tubular motor starts 1 x,
LED indicator flashes 4 x
Connect the shutter motor to the SP50 solar module:
•
Slide the rotary lock of the SP50 solar module connection to the rear.
Before connecting the connecting cables, make sure that the markings (arrow) are opposite each other.
>
fig. 1
•
Connect solar module SP50 and shutter motor together.
>
fig. 2
•
Fix the connection of the cables with the twist lock. Close the twist lock tightly to prevent water from entering.
>
fig. 3
•
After programming, disconnect the connection cables again for mounting.
1
Connection
SP50
Connection
tubular motor
2
3
Twist lock
Note:
When programming, make sure that the direction of rotation of the motor is correct.
This means that the direction of rotation does not have to be changed after assembly.
3T-MOTORS Tubular motors 12V
| Programming
