13
7
Mount solar module SP50:
•
Mount the solar module to the wall or roof using one of the following options:
8
Connection roller shutter motor + solar module SP50:
•
Connect cables of shutter motor and solar module SP50 (see description page 6).
•
If the drive should run in the opposite direction after installation, the direction of rotation must be changed via the solar panel SP50.
(see programming page 7).
•
Insert the wall brackets (1) into the fasteners and secure them
with the screws (2) supplied.
•
Fix the fastenings with the supplied grub screws (3) at the desired
position with hexagonal wrench.
•
Mount the wall brackets on the wall with the supplied dowels and screws.
•
Attach the clip holder (1) to the wall or roof with suitable screws and dowels.
When doing so, take the desired angle into account.
•
Snap the solar module into the clip holder.
Mounting with 2 wall brackets:
Mounting with clip bearing:
•
On the opposite side of the motor, push the roller capsule out of the roller shutter shaft until it fits into the ball bearing inserted in the wall bearing.
•
Fix roller capsule to roller shutter shaft with self-tapping screw. Position the screw at a punched hole. This prevents the screw from slipping.
SP50 Rear with wall brackets
SP50 Rear with clip bearing
2
2
3
1
1
1
3
INSTALLATION INSTRUCTIONS
3T-MOTORS Tubular motors 12V
| Installation instructions
Roller capsule
Wall b
Ball bearing
