device is abnormal.
Blinking
Blinking 1 time per second, the
device is running normally.
Link/Act
(G1-G16,
X1-X4)
ON
Ethernet port has established a
valid network connection
Blinking
Ethernet port is in an active
network status
OFF
Ethernet port has not established
valid network connection
【
Logging in to WEB Interface
】
This series supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device’s configuration interface via IE
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed
Step 2
Enter device’s IP address in the address bar of the
computer browser.
Step 3
Enter device’s username and password in the login
window as shown below.
Step 4
Click “Login” button to login to the WEB interface of
the device.
Note:
The default IP address of the device is “192.168.1.254”.
The default username and password of the device are
“admin123”.
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【
Specification
】
Panel
10Gigabit SFP+ slot
1000/10GBase-X self-adaptive
SFP+ slot
Gigabit SFP slot
100/1000Base-X self-adaptive
SFP+ slot
Gigabit copper port
10/100/1000 Base-T(X)
self-adapting RJ45 port, half/full
duplex self-adaption or forced
working mode, support MDI/
MDI-X self-adaption
Console port
CLI command management
port (RS-232), RJ45
Alarm interface
6-PIN 5.08mm pitch terminal
blocks, alarm terminal blocks
occupies 2 pins, and support 1
relay alarm output, current load
capability is 1A@30VDC or
0.3A@125VAC
Indicator
Power supply indicator, run
indicator, interface indicator,
alarm indicator
Switch Property
Backplane bandwidth
128G
Packet buffer size
12Mbit
MAC Address Table
16K
Power Supply
Input power supply
Voltage range: 12~48VDC.
Support dual power supply
redundancy, anti-reverse
connection
Support built-in 3.0A
overcurrent protection
Access terminal block
6-PIN 5.08mm pitch terminal
blocks (power supply occupies
4 pins)
Power Consumption
No-load
9.6W@12VDC
Full-load
17.76W@12VDC
Working Environment
Working temperature
-40
～
75
℃
Storage temperature
-40
～
85
℃
Working humidity
5%
～
95% (no condensation)
Protection grade
IP40 (metal shell)
