3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 -
Revision 1.8
Page 12 of 65
Configuration
Change the Night Volume
You can assign a standard reduction in the volume level of the customer order point speaker
for night hours when lower volume is typically required. With the night volume set, the system
automatically adjusts the volume during night hours, then back to normal during the day.
•
To change the night volume setting:
•
Enter the configuration mode, see page 5.
•
Select a new value for
03 Night Volume
>
Reduce DriveThru Volume
At Night By
. The range is 0 to the current day volume level.
Notes:
Night Volume is never higher than Day Volume.
Night volume reduction is a subtracted value, not the resulting level; therefore, if it is the same as
the day volume level, the speaker will turn off at night.
You cannot change the day outbound talk volume on this screen, only the reduction amount
identified above.
Registering Headsets
Each headset must be registered to a base station before it can be used. Once registered,
it should not need to be registered again unless it is intentionally removed.
Add Headsets
Each headset has a unique identification number. The number is imprinted on the
headset and broadcast to the base station whenever it is turned on.
Notes:
One headset should not be registered to more than one active basestation at any given site, whether
or not the bases are interconnected.
In dual-lane installations, all headsets are registered to Base #1.
To register a headset:
•
Enter the base station configuration mode, see page 5.
•
Select
04 Registration
>
1 Add New Headsets
.
•
Power on the headset when prompted.
•
Wait up to two minutes for
{Headset xxxxxxx Has Been
Registered!}
to appear at the bottom of the display.
•
Repeat step 3 for additional headsets.
•
Press
Mode
when finished.
