3M Workstation Monitor 724, Руководство пользователя

Страница: 10 / 25

10
SECTION 2
Installation of 3M
™
Workstation Monitor 724 with Work Surface
Ground Monitoring
Wire Attachments and Grounding - See Figure 12 for complete drawing of the
Workstation 724 wire connections.
Tools required – Small blade, screwdriver and wire cutter.
a) Connect the work surface to an electrical
ground with the appropriate one megohm
ground cord you received at time of purchase.
b) Using a small screwdriver move the DIP
switch #2 on the Workstation Monitor 724
to the ON position to activate the work
surface audible alarm (Figure 4).
c) Locate the accessory package that contains
a 3M
™
Monitor/Table Mat Cord 2380D,
Workstation Monitor 724 ground wire (with
ring terminal), and the two-wire connector
plug.
d) Attach the 3M Monitor/Table Mat Cord
2380D (tinned wire end) to the work surface
terminal of the two-wire connector by
inserting it into opening and securing with
the screwdriver (Figure 5A or 5B). Attach
the plastic cap end to the snap on the work
surface.
e) Determine how you want to ground the
Workstation Monitor 724:
• If you are grounding through the AC
adapter perform step (2f).
• If you are grounding through the
Workstation Monitor 724 ground wire perform step (2g).
f) Attach the tinned ground wire of the AC adapter to the ground terminal of the
two-wire connector by inserting it into opening and securing with screwdriver
(Figure 5B). Continue with step (2h).
g) Attach the tinned Workstation Monitor 724 ground wire to the ground terminal
of the two-wire connector by inserting the tinned end into opening
and securing with screwdriver (Figure 5A). Attach the ring terminal end with a
screw (not supplied) to an electrical ground (Figure 7B). Continue with step (2h).
Note: Two snap fasteners or
appropriate connectors must be
installed at opposite corners of the
work surface to use this feature.
For recommended surfaces to use
with the 3M
™
Workstation Monitor
724 please refer to Section 14. Use
of a 3M
™
Female Snap Fastener
3034 or 3050 (depending on the
type of surface) is recommended
for connection to the 3M
™
Monitor/
Table Mat Cord 2380D that is
supplied with the Workstation
Monitor 724. If you are using the
3M
™
Dissipative Hard Laminate
Material 8300, attach the Monitor/
Table Mat Cord 2380D to suitable
hardware used to make an electrical
connection to the ground layer of the
work surface. This may require you
to cut off the plastic cap end of the
Monitor/Table Mat Cord 2380D.
Note: If for any reason a snap fastener
cannot be used on the work surface,
the plastic cap on the end of the 3M
™
Monitor/Table Mat Cord 2380D can
be cut off and replaced with a ring
terminal not supplied (Figure 6).