31
[Communication Speed]
Use this to specify the communication speed.
1Mbps, 2Mbps, 5.5Mbps, 11Mbps or AUTO
Normally, setting to AUTO should present no problems. However, if you are experiencing
difficulties due to distance and/or obstructions, you might want to try a low speed setting.
[Projector Name]
Use this to specify the name of the projector (that the
EP
8
79
0
NET
module is mounted to). (This will actually be
stored on the
EP
8
79
0
NET
module, not the projector.) Should there be multiple projectors, this name will be helpful
for distinguishing between projectors in LiveViewer. In addition to single-byte alphanumeric characters and
spaces, you may also use the following symbols. The length of the name can be up to 255 characters long:
! " # $ % & ' ( ) = @ \ ? < > _ , . * + - / | [ ] { } ; :
Press Reset to restore the current
settings.
Once you have completed configuring the network settings, press Write. If the following message
appears, you will know that the settings have been successfully changed. (However, you need to
turn the
EP
8
79
0
NET
module off and then on again for the new settings to take effect.)
However, if the following message appears, your attempt to change the settings has failed. Should this
occur, check the communication status with the
EP
8
79
0
NET
module.
You can also use the menu of the projector (that the
EP
8
79
0
NET
module is mounted to) to confirm the
projector name. However, when you use that menu you can only view 16 characters at a time.
NOTE
3M™ Wireless Network Module EP8790NET
© 3M 2003. All Rights Reserved. 3M™ Multimedia Projector MP8790
