3M W100, Руководство пользователя

Страница: 27 / 58

15
6-INSTALLATION
(continued)
2011 October
WaterAct-M-S
6-8 Brush Tank Water Level Adjusting
(Figures 6-7 and 6-8).
1. Loosen the retaining screws on the water bottle
brackets.
2. Move the water bottle brackets to the desired
position to obtain the desired water level in the
brush tank (Both brackets should be at the
same position).
Note:
Lightweight tapes would typically be set
at the low position
(Figure 6-8).
3. Tighten the retaining screws on the water bottle
brackets.
6-9 Tape Weight Adjusting
(Figure 6-7)
1. Loosen retaining screw.
2. Slide tape weight forward for greater
pressure (this applies more water to tape
and is typically used on heavy weight tapes).
3. Slide tape weight back for less pressure.
(this applies less water to tape and is
typically used on lighter weight tapes).
4. Tighten retaining screw.
Figure 6-8
Water Bottle
Bracket
6.7 Water Bottle Filling (Figures 6-7 and 6-8).
1. Remove water bottle from dispenser.
2. Remove duckbill valve from water bottle.
3. Fill water bottle with clean or distilled water
(Figure 6-7)
.
4. Place duckbill valve back into water bottle.
5. Place water bottle back on the dispenser.
Check to be sure the post in the brush tank is
inserted through the duckbill valve
(Figure 6-7).
High
Low
Medium