3M VF-45, Инструкция по эксплуатации

Страница: 23 / 32

23
5.3 The face of the polishing assembly can be replaced in the
fields by depressing the spring on the bottom of the puck
assembly and snapping new face into place.
5.4
If insertion of the fiber becomes difficult, inspect the
fiber guide holes of the polishing face.
Use the fiber view scope to inspect the fiber guide holes.
Check for debris in the fiber guide holes.
5.5
Clean the fiber guide holes of the polishing face.
If the fiber guide holes become plugged, they may be
cleaned by opening the face of the polishing puck,
holding the alcohol bottle against the inside face area
and directing alcohol through the holes. If alcohol stream
does not dislodge debris, a piece of cleaning wire may be
used to clean the holes (included in kit).
Note: Carefully follow safety, health and environmental
information given on container label or Material Safety
Data Sheet for isopropyl alcohol being used.