Page 23
3M
™
Straight Line Laminator Single Head Manual
|
Original Assembly and Operation Instructions
Effective: August 2022
Figure 15
1 . Unlock the locking bolt (Figure 15A) to release the spring tension .
2 . Unhook the compression spring on one side of the spring holder (Figure 15E) .
3 . Loosen the lock nut M8 DIN 934, spanner size 13 (Figure 15C) and unscrew the base plate connector
(Figure 15D) .
4 . Screw the base plate connector (Figure 15D) into another mounting position (Figure 15B) and lock it
with the nut M8 DIN 934, spanner size 13 (Figure 15C) .
Mounting position upwards: Increasing the spring tension.
Mounting position downwards: Decreasing the spring tension.
5 . Hook the compression spring with the loosened side back into spring holder (Figure 15E) .
The compression spring is newly adjusted.
6.3 Installation of the Unit
The unit is mounted by the operator on an existing worktable . This can be done using the two mounting
brackets (Figure 16A) .
Figure 16
1 . Place the unit in the desired position on the worktable .
2 . Remove the cover from the mounting bracket (Figure 16C) .
3 . Use an Allen key size 6 for screw M8 (Figure 16B) to loosen or tighten it .
The continuous laminator is installed.
A
B
A
A
B
C
C
D
E
