3M
™
Super Close Projection System SCP716/SCP716W
Product Safety Guide
©
3M 2009. All Rights Reserved
6
To reduce the risk associated with hazardous voltage:
•
Do not operate this projector in wet environments or outdoors.
•
Do not modify this projector or power cord.
•
Do not remove any screws other than those specified in the lamp replacement instructions.
•
Do not attempt to service the projector other than the lamp cartridge. There are no user serviceable parts inside the projector.
•
Contact a 3M authorized service provider for service.
•
Disconnect power cord when the projector is not in use for extended periods of time, during lamp replacement, and while cleaning.
•
Do not allow water or other liquids to enter the projector.
To reduce the risk associated with hazardous voltage and/or fire:
•
Replace power cord if damaged.
•
Contact a 3M authorized service provider if the projector becomes damaged.
•
Use a grounded extension cord with a rating at least equal to that of the projector.
•
Connect this projector to a grounded outlet.
To reduce the risk associated with choking:
•
Keep the battery and battery cover away from children and pets.
To reduce the risk associated with lamp rupture related hazards:
•
In event of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is not user serviceable.
•
Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
•
Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
To reduce the risk associated with hazardous voltage, impact, tripping, or intense visible light:
•
Do not use this projector around unsupervised children.
To reduce the risk associated with sharp objects, premature lamp failure, exposure to mercury:
•
Always handle the fragile lamp module with care.
•
Replace the lamp module when the lamp replacement message appears.
•
Never replace the lamp module with a previously used lamp module.
•
Remove the projector from the ceiling or wall mount before replacing the lamp.
To reduce the risk associated with intense visible light:
•
Avoid looking directly into the projector lens while the lamp is on.
To reduce the risk associated with impact of a falling projector:
•
Use only the 3M brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired.
•
Installation of the 3M brand wall/ceiling kit must only be performed by qualified personnel.
•
Adhere strictly to the proper installation procedure as outlined in the installation instructions when installing the 3M Wall/Ceiling kit.
•
Always operate the unit on a flat and sturdy surface.
To reduce the risk associated with explosion, and/or chemicals from leaking battery:
•
Use only with battery type AAA.
•
Orient the battery’s plus (+) and minus (-) terminals according to the markings found on the remote control.
•
Do not leave the battery in the remote for an extended period of time.
•
Do not heat, disassemble, short, recharge, or expose the batteries to fire or high temperature.
•
Do not carry batteries loose in your pocket or purse.
•
Avoid eye and skin contact in the event that battery would leak.
•
Do not mix used and new batteries.
To reduce the risk associated with tripping, and/or impact:
•
Position the power cord and cables so that they can not be tripped over.
To reduce the risk associated with environmental contamination:
•
Dispose of mercury lamp, exhausted batteries, and other electronic components in accordance with applicable federal, state and
local regulations.
To reduce the risk associated with hot surface of lamp cartridge:
•
Before replacing the lamp, allow the lamp to cool for 60 minutes and then unplug the projector from the electrical outlet.
To reduce the risk associated with environmental contamination due to mercury:
•
Hg: Lamp contains mercury. Don't throw in trash. Dispose according to local, state, or federal laws.
See www.lamprecycle.org or call 1-800-328-1371.
SAVE THESE INSTRUCTIONS
WARNING
CAUTION
