9
Note:
When powered off and properly fit in the ear canal, the earplugs will still help provide
hearing protection.
Using the EEP-100 earplug
1.
Power On:
Turn the product on by pressing and holding the power/control button for
2 seconds (Fig. A:1). This is referred to as a “long” press. You may release the button when
you hear a tone. The earpiece should now be on and in the low volume setting. Repeat this
process for the other earpiece.
Note:
When the earpiece is turned on and properly fitted in your ear, sound entering your ear
should not sound distant, faint, or muffled. If it does, make sure the device is turned on.
2.
Environmental Listening:
When the earplugs are powered on, the user can adjust the
volume to a comfortable setting by quickly pressing and releasing the power/control button.
This is referred to as a “quick” press. When powered on, the earpieces allow sounds to
pass through in quiet environments while restricting the volume level in loud environments.
Upon
power on, the EEP-100 defaults to the low setting, which reproduces the environmental
sounds at a reduced level. Each setting is indicated by a unique tone.
• Audio levels are selectable by pressing the power/control button momentarily.
This cycles through three audio levels: low, medium, and high.
3.
Power Off:
Press and hold the Power/Control button for two seconds, until a double beep is
heard. Then the button can be released and the earpiece is powered off. Repeat this process
for the other earpiece (Fig. A).
Note:
When powered off and properly fit in the ear canal, the earplugs will still help provide
hearing protection.
Attach/Detach Windscreen (not included with EEP-100)
The windscreen may help minimize wind noise in high wind conditions.
Note:
For the EEP-100, windscreens may be purchased (see, "Reorder).
1. Remove a disposable windscreen from the perforated windscreen sheet backing (Fig.G:1).
2. Locate the earplug microphone (Fig.G:2).
3. Carefully center the disposable windscreen over the microphone port and press the
adhesive backed windscreen to the microphone port (Fig.G:3).
4. To detach, remove the windscreen and dispose when necessary. To attach, follow steps 1-3.
Note:
After storing and/or recharging the earplug in the charging case, it may be necessary to
remove the old disposable windscreen and replace with a new screen.
G:1
Fig. G
G:2
G:3
