3M Multimedia Projector MP8795, Руководство по безопасности

Страница: 9 / 52

Note
For maximum lamp life, do not apply shock, handle or scratch the lamp glass when it is hot. Also, do not use an
old or previously used lamp as a r eplacement lamp.
1. Remove lamp access door: The lamp access door is located on the bottom of the machine.Use a screwdriver to unscrew
the cover retaining screw (1) and gently remove the cover (2) and set it aside.
2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (3)
Note
All lamp module screws must be loosened. These scr ews are self-containing scr ews that cannot be removed
from the lamp module or access door .
3. Remove lamp module: Carefully slide the lamp module out (4) using steady pressure.
4. Insert lamp module: Carefully insert (4) the new lamp module. Ensure that it is fully seated. Tighten the
lamp module retaining screws (3) to secure the lamp module in place.
Insert the hinge tabs on the bottom of the lamp access door, then close and tighten the retaining screw
(1) to secure the door.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes befor e replacing th e
lamp.
To reduce the risk of cuts to fingers and damage to inter nal components, use caution when r emoving lamp
glass that has failed and shatter ed into sharp pieces.
Caution
WARNING
To reduce the risk of electrical shock, always turn off pr ojector and disconnect power cor d before changing
lamp.
To reduce the risk of cuts to fingers from sharp metal fittings and/or decr easing image quality by touching the
lens, do not insert hand into the empty lamp compartment when the lamp has been removed.
Caution
Replacing Lamp
Note
Reset the lamp operation hours. See “Reset Lamp Hours” for details.
✔
✔
✔
Optional Lamp: 78-6969-9548-5 (Contact 3M customer Service.)
1
2
3 3
4
9 © 3M 2003 3M™ Multimedia Projector MP8795 Product Safety Guide
ENGLISH
MP8795 03.1.22 1:44 PM ページ 9