3M 3M-Matic Accuglide NPH 11200, Инструкция и перечень запасных частей

Страница: 24 / 52

16
Troubleshooting
Cause
The tape is threaded incorrectly
The tape tension is too low
Tape tracks to one side or drags
on the support tabs of applying
frame
The blade is dull and/or has
broken teeth
Tape tension is insuf fi cient
Adhesive has built up on the blade
The blade is not positioned
properly
The blade is dry
The blade is in backwards
Cutter Spring is missing or
stretched
Tension roller surface is not fully
contacting the taping head frame
Taping Head not positioned
properly
Correction
The tape must go around the wrap
roller before going around the
one-way tension roller
Adjust the one-way tension roller
Adjust the tape web alignments
Replace the blade
Increase tape tension by adjusting
the one-way tension roller
Clean and adjust the blade
Make sure the blade is bottomed
out against the mounting bolts
Lubricate the blade oiler pad on
the blade guard
Mount the blade so that the
beveled edge is away from the
entrance of the head
Replace the defective spring
Make sure one-way bearing is
below the surface of the tension
roller. If not, press bearing further
into roller or replace roller.
Adjust Taping Head so there is
less than 1/8" gap between case
and upper assembly
Troubleshooting Guide
Problem
The tape leg on the front of the
case is too long
The blade does not cut tape or the
tape end is jagged or shredded
NPH 2" - NA
2014 December