3M 3M-Matic Accuglide NPH 11200, Инструкция и перечень запасных частей

Страница: 18 / 52

10
It is recommended that the detailed instructions and
sketches in this manual be referred to the
fi rst few
times the taping head is loaded/threaded until the
operator becomes thoroughly familiar with the tape
loading operation.
Note –
Remove tape roll before removing taping
head from machine to minimize weight.
Operation
(continued)
Figure 3-3
Insert tape through rollers in direction indicated by
arrows.
5. Pull the tape down past the applying roller
(Position 4). When properly threaded the
adhesive side of the tape should be facing the
tension roller at position 2 and away from the
guide roller at position 3.
6. Cut away any excess tape.
Important –
Do not cut against the apply roller -
roller damage could occur.
Tape Loading – Lower Taping Head
1. Remove the lower taping head from the conveyor
bed or associated equipment and place it a
convenient working position.
2. The lower taping head is loaded and threaded in
the same manner as the upper head. Follow the
upper taping head tape loading/threading procedure.
Tape Loading – Upper Taping Head
1. Place the upper taping head in a convenient
working position.
2. Use
Figures 3-3 to 3-5
and tapel label. Position
the tape supply roll so the adhesive side of tape
is facing the front of the taping head as it is pulled
from the supply roll.
3. Guide the tape around the tension wrap roller
(Position 1) then back around the one-way ten-
sion roller (Position 2).
4. Continue pulling the tape down and past the wrap
roller (Position 3) and through the Tape Support
Assembly.
•
To reduce the risk associated with shear, pinch, and entanglement hazards:
− Turn air and electrical supplies off on associated equipment before performing any adjustments,
maintenance, or servicing the machine or taping heads.
− Never attempt to work on the taping heads or load tape when the box drive system is running.
•
To reduce the risk associated with sharp blade hazards:
− Keep hands and fi ngers away from tape cutoff blades under Yellow blade guards.
The blades are extremely sharp.
•
To reduce the risk associated with
muscle strain:
− Use proper body mechanics when
removing or installing taping heads that
are moderately heavy or may be
considered awkward to lift.
•
To reduce the risk associated with
impact hazards:
− Place the taping head on a smooth
level surface when maintaining or
servicing this equipment.
CAUTION
NPH 2" - NA
2014 December
4.Tape Support Finger
Figure 3-3
Tape Loading /
Threading
One-Way
Tension Roller
1
2
3
4
Wrap Roller
Tension
Wrap
Roller
Tape
Support
Assembly
WARNING