3M 3M-Matic AccuGlide 2+ 800af, Инструкция и перечень запасных частей

Страница: 55 / 106

45
IMPORTANT –
It is recommended that no less than two people assist on this set-up or severe injury or
equipment damage could result.
14.3 Outer Column Re-Positioning
(Refer to
Figure 14-4
)
Moving the outer columns up one set of mounting holes increases the maximum box size handled by the case
sealer from 620mm [24-1/2 inches] to 725mm [28-1/2 inches].
To move the outer columns up one set of mounting holes:
1. Crank side drive belts to full open position.
2. Crank upper taping head frame assembly up approximately 330mm [13 inches] from machine bed.
3. Place solid blocks approximately 305mm [12 inches] high beneath upper taping head frame at rear of taping
head and under front fl ap folding ski
(Figure 14-4A).
Note –
Blocks (front and rear) must be the same height in order to keep upper frame level.
4. Crank upper taping head frame down until weight of upper frame is fully on blocks.
5. Remove and retain six mounting screws in each outer column assembly
(Figure 13-4B).
6. Crank outer column up 100mm [4 inches] and re-install six (6) screws in each column. Tighten screws.
7. Crank upper taping head up and remove blocks.
8. Check horizontal alignment of upper taping head frame and adjust as described in "Adjustments – Upper Tap-
ing Head Leveling".
IMPORTANT -
A second person should assist with this part of set-up to hold (steady) upper frame
until columns are re-positioned and column screws are installed and tightened.
2010 December
800af-I-NA
14 - SPECIAL SET-UP PROCEDURE
(continued)
306mm
[12 inches]
(Minimum)
100mm
[12 inches]
Minimum
Machine
Frame
Outer
Column
Figure 14-4 – Column Re-Positioning
A
B