3M 3M-Matic 8000af, Инструкция и перечень запасных частей

Страница: 46 / 160

North American - ENG
Date Released:
October 2018
3M-Matic ™ 8000af - Type 11800
Page 34
44-0009-2153-4 / ECO# 0078045
Figue 12-1 Lubrication Points
The case sealer been designed for long,
trouble- free service. The machine will perform
best when it receives routine maintenance
and cleaning. Machine components that fail or
wear excessively should be promptly repaired or
replaced to prevent damage to other portions of
the machine or to the product.
Note – Never attempt to remove dirt by blowing
it out with compressed air. This can cause
the dirt to be blown inside the motor and
onto sliding surfaces which may cause
premature equipment wear. Never
wash down or subject equipment to
conditions causing moisture condensation
on components. Serious equipment
damage could result.
Note – Wipe o
ff
excess Silicone. It will attract }
dust and dirt which can cause premature
equipment wear and jamming. Take care
that Silicone is not left on the surface of
rollers around which tape is threaded, as it
can contaminate the tape's adhesive.
12.1 Cleaning
Regular slotted containers produce
a great deal of dust and paper chips
when processed or handled in
equipment. If this dust is allowed to
build up on machine components,
it can cause component wear and
overheating of drive motor.
The dust build-up can best be
removed from the machine by
a shop vacuum. Depending on
number and type of boxes sealed,
this cleaning should be done
approximately once per month.
If the boxes sealed are dirty, or
environment in which the machine
operates is dusty, cleaning on a more
frequent basis may be necessary.
Excessive dirt buildup that cannot
be removed by vacuuming should
be wiped o
ff
with a damp cloth.
12.2 Lubrication
Most of the machine bearings,
including the drive motor, are
permanently lubricated and sealed
and do not require additional lubricant.
Figure 12-1 illustrates the areas of
the case sealer that require lubrication.
Lubricate points indicated by arrows
with Synthetic Silicone.
TAPING HEAD LUBRICATION –
See Manual 2 "Maintenance – Lubrication".
• To reduce the risk associated with
pinches, entanglement and
hazardous voltage:
−
Turn electrical supply o
ff
and
disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
Warning
12. Maintenance