3M 3M-Matic 700r3, Инструкция и перечень запасных частей, Страница: 30 / 144

20
7-INSTALLATION
(continued)
2012 January
700r3-NA
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks
(Figure 7-4).
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame
(Figure 7-5).
Cut the plastic ties holding the lower taping head in
position
(Figure 7-6).
Figure 7-4
Figure 7-5
Figure 7-6
7.6 Assembly Completion / Machine Setup
1.
Install the upper tape drum bracket on the top
crossbar as shown in
Figure 7-7A
.
2.
The column guards, shown in
Figure 7-7
have
been installed upside down for shipping. Remove
and retain the screws and washers holding the
guards on the columns for re-installation after
the Bumper Supports have been mounted (see
Column Bumper Installation in the Installation
and Setup Section and Special Setup Procedures
Section /
Figure 7-7
). After the Bumpers have
been installed, the Column Guards must be
repositioned (rotated 180° and re-installed -
Figure 7-7
) for safe operation of the machine.
Replace existing screws and washers to secure
the guards in place.
3.
Cut cable ties securing upper assembly to
machine bed on each side.