3M™
Heavy-Duty Assembly Press, 3335
Instructions
3M
Electronics Materials Solutions Division
Interconnect Solutions
http://www.3m.com/interconnect/
For technical, sales or ordering information call
800
–225–5373
5.
Rotate the locking collar firmly against the
adjustment collar, securing the adjustment
setting. (see figure 3)
6.
Replace the pressure platen in either of two
positions, referring to the adjustment setting
sheet for the correct position. Most positions are
parallel to the length of the connector.
Maintenance:
It is not necessary to disassemble the press for
lubrication. Apply a few drops of S.A.E. 10 oil on
the six pivot points at least every 5,000 connections.
Apply a small amount of light grease to the shaft
near the bearing areas.
