3M 2178-XLB, Инструкция по эксплуатации

Страница: 8 / 16

8
78-8135-0094-5-K
3.9.1 Collars should be built up to 1.45"
diameter for large port and 1.05"
diameter for the smaller port. Use the
tape collar gauge provided in kit to
measure for required diameter.
1.05"
end
1.45"
end
Figure 10
3.10 Thinly coat all surfaces of cable ports and tape
collar with silicone lubricant and insert into
gasket at the proper port. Insert cable retention
clamp into slot at same time and push down
until cable is in proper alignment.
Note: Ensure that washers are properly seated in the
grooves of the case on either side of the gasket.
Note: Carefully follow health and safety
environmental instructions as given on Material
Safety Data Sheet for the silicone lubricant.
Figure 11
3.11 Using two (2) black cable ties, retain cables in
ports by placing ties both inside and outside
the base.
Note: White cable ties are shown for clarity.
Figure 12