3M 2178-XLB, Инструкция по эксплуатации

Страница: 12 / 16

12
78-8135-0094-5-K
6.0 Tray Installation and Splicing
6.1 Once cables have been anchored, place tray
support in position and tighten two (2) screws.
6.2 Cut two 3M
™
Reclosable Dual Lock
™
Fasteners in half. Remove liner from two
pieces of fastener and place on tray support as
shown. Mate second two pieces of fastener to
the attached pieces. Remove liner from back
of top pieces and attach first tray.
Figure 21
7.0 Fiber Management Inside Tray
7.1 Select appropriate splice holder based on type
of splicing to be performed
7.2 Remove adhesive backing and position splice
holders on tray.
Note: Positioning of splice holders should be such
that a minimum of 1.5" (40 mm) bend radius is
maintained for each fiber to be spliced.
Note: In a dirty environment an alcohol wipe may be
used to clean tray surface for better adhesion.
Note: Carefully follow safety, health and environmental
information given on product label or the
Material Safety Data Sheet for the cleaner.
7.3 Route buffer tube or ribbon to desired tray
corner.
Note: Do not exceed minimum 1.5" (40 mm) bend
radius during routing process.
7.4 Secure loose buffer tube to tray using the
supplied cable ties.
Figure 22