http://www.3jtech.com.tw
http://www.3jtech.com
CAMit I+gsm
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
21
number when it is triggered. Please enter the number you wish in the box.
Time Duration for each attempts (sec):
This parameter will set the duration that the camera will kept ringing until pick up.
Please enter the time you desire in the according box.
Time delay between each call (sec):
This is the time delay between each call back. Please enter the time you desire in the
according box.
Number to dial upon trigger:
CAMit I+GSM will allow you to have multiple numbers to call back. You can set up to 4
sets of number to call back. Simply insert the number you wish the camera to dial in the
boxes below. The camera would only dial the boxes with numbers inserted.
Note. Please be aware of the area code for the call back number. You might have to place
the area code in order for the number to be valid. Please make sure that if you’re dialing off
state, the area code is added.
Manually Enable Trigger Output:
By enabling this function, you will be able to
turn on the trigger out device manually. Simply
check or uncheck to turn the device on and off.
Time Output Duration Upon Trigger (sec):
This parameter is used along with the trigger in or motion detection function. It will allow you
to set the time duration for the Trigger Out device to be turned on. To set this parameter,
please inset the desire amount of seconds in the according text box.
Security Function Delay Time upon Activation:
This is the time lag which the motion detection
will activate after you save and reset the
camera. Please enter the time you wish to set for the time lag.
5.1.4 View Images
You will be able to view the images when connecting via RS232 to verify the clearness of
the image. To browse the image, please
click
View Images
button at the bottom of
the setup window.
A new window should load upon the click of the button. To start receiving images, please
