Ver 1.0.0.1
Since 1988
2
3. Hardware Connection Settings for the Dongle Mode
(Please skip this section if you would like to use the EDGE mode connection. For more details about the mode
switching, please jump to Section 4.)
1) Plug the Bluetooth dongle into the BT connector on your EDGE Super Router.
2) Connect the LAN port of a router to LAN port of your EDGE Super Router using a RJ45
cable.
3) Screw the antenna to 3G ANT SMA connector on your EDGE Super Router.
4) Connect the power cable to the power connector of your EDGE Super Router.
4. Mode Selection between EDGE Mode and Dongle Mode
EDGE Super Router supports two modes in operation. For the correct position of these two
switching mode, please refer to the figure below.
Note:
EDGE Mode: Push the switch backward, PC
will get the virtual IP address from EDGE
Super Router.
Dongle Mode: Push the switch frontward, PC
will get the IP address from the router you
connected.
