PANNORAMIC® DESK FLASH DX
MAINTENANCE
62
INFORMATION FOR USE
–
FOR INVESTIGATIONAL USE ONLY.
THE PERFORMANCE CHARACTERISTICS OF THIS PRODUCT HAVE NOT BEEN ESTABLISHED.
Planned Maintenance
Throughout the entire life cycle of the Scanner, some of its components must be periodically
inspected, serviced or replaced in order to maintain proper operation and ensure image quality.
Warning!
The servicing and service maintenance of the Scanner must be performed by qualified and
trained Service Technicians only (and
NOT
by the user).
Routine user checks are necessary if the control software instructs you to do so. These tasks
are simple, but can be performed by trained users only.
Repair and maintenance service provided by 3DHISTECH is always carried out in accordance with
the contractual agreement. 3DHISTECH service technicians are qualified and holding a license,
therefore, are authorized to perform any maintenance and repair tasks on the Scanner.
Routine User Checks Program
Warning!
Under the contract with the manufacturer / distributor, the owner of the equipment is
obliged to provide users with adequate training and to make sure that the equipment is
used properly. It is the owner’s responsibility to ensure that routine user checks and
maintenance tasks are performed in time / on a timely basis.
If during the operation a possible defect or malfunction of the Scanner is suspected, the
user must immediately contact 3DHISTECH for service, and the Scanner must be switched
off and cannot be further operated. The Scanner can only be used further once the Service
technician eliminated the problem, or has performed the necessary repair, otherwise, using
the Scanner although it has not been repaired or checked may lead to misdiagnosis or
mistreatment.
Routine inspection tasks on a timely basis must be performed by the user. Such tasks are the
following:
•
Yearly
–
Overall maintenance
